1. Tank type: vertical; cylinder: cylinder;
2. Upper disc seal and lower cone seal; lower cone angle: 60°;
3. Equipment material: stainless steel 304;
4. The thickness of the insulation layer is 100mm;
5. Working pressure 3bar, test pressure 4bar;
6. Inner bladder polishing coefficient: ≤0.6 µm;
7. Three-stage cooling jacket (tube body 2 section and lower cone 1 section), the cylinder body 2 section cooling jacket should be larger, so that one section of the cooling jacket can make 5000L beer, and the other section of the cooling jacket can make 10 tons For beer, each cooling jacket has an ice water inlet and an ice water outlet. The inlet and outlet are DN outer wires, and they must be controlled separately.
8. All connection methods are DIN connection;
9. The distance between the wine drain and the wine outlet is 400mm from the ground;
10. The horizontal direction of the wine outlet pipe is required to extend out of the tank.
11. The bottom of the cone is connected to a flange with a diameter of 100mm. The flange has 2 ports, one is the wine outlet and the other is the sewage outlet, the diameter is DN40mm;
12. All accessories must comply with CE certification;
12. The size is 600mm top side manhole;
13. The mechanical pressure regulating valve is Kieselmann, and the mechanical pressure regulating valve is installed at the end of the CIP pipe;
14. With sight glass on the top of the tank;
15. All bolts must be stainless steel;
16. The pressure gauge must be stainless steel;
17. Cylinder surface: wire drawing board, welding seam polishing treatment;
18. Washing method: rotating spray ball, the spray ball can be disassembled, which facilitates inspection and removal of impurities;
19. Support: stainless steel legs with adjusting bolts;
20. The designated manufacturer of pt100 temperature transmitter is (Anh Nghi Son service trading Co ltd);
21. The lower cone has a bell mouth, and a sampling valve is connected to it, which is of good quality;
21. Sampling valve, temperature sensor, mechanical pressure regulating valve, breathing valve, ice water solenoid valve, butterfly valve;
twenty two. Matching valve;
23. The mechanical pressure regulating valve and the sampling valve are connected by a hose to form a cleaning circuit of "CIP pipe, CIP cleaning ball, tank, sampling valve, mechanical pressure regulating valve", the purpose is to clean the sampling valve and For pressure regulating valve and tank, please see the attachment;
24. The tank top has a stainless steel protective cap to protect the pipe fittings on the tank top. The protective cap is connected to the top by a hinge;
25. The DN40 CIP elbow extends from the top of the tank to a height of 1500mm from the ground;
26. Power supply voltage: 380V, 50HZ, 3-phase electricity.